c-lab:3d-drucker
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| c-lab:3d-drucker [2025/02/25 23:13] – created hrmny | c-lab:3d-drucker [2026/05/05 20:43] (current) – [Start] uk | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== 3D Printer ====== | ====== 3D Printer ====== | ||
| + | |||
| + | Bambulab X1C (X1-Carbon) | ||
| + | |||
| + | * 256 x 256 x 256 mm³ | ||
| + | * Two Automated Material Systems (AMS) | ||
| + | |||
| + | ===== New Members ===== | ||
| + | |||
| + | Please get an introduction from one of the existing members before using the printer. | ||
| ===== Responsible Persons ===== | ===== Responsible Persons ===== | ||
| Line 7: | Line 16: | ||
| * dazz | * dazz | ||
| * hrmny | * hrmny | ||
| + | * ijon | ||
| * ligi | * ligi | ||
| + | * pico | ||
| + | * riot | ||
| + | * shift | ||
| + | * uk | ||
| ==== Requirements ==== | ==== Requirements ==== | ||
| Line 49: | Line 63: | ||
| - Check the first layer | - Check the first layer | ||
| - | TODO: Automate matrix message via MQTT? | ||
| ==== During Printing ==== | ==== During Printing ==== | ||
c-lab/3d-drucker.1740525192.txt.gz · Last modified: 2025/02/25 23:13 by hrmny
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
